tim TKW1
Member
I am trying to set up a DP coupler to use with a TI555-1105 PLC and an S7-300. I am using Com-Profibus to configure the profibus network and the DP coupler modules. I am able to configure the modules for bit data transfer with no problem but I cannot pass any word data unless I set up the DP coupler configuration with "64 word" module. I know there is a way of converting the byte modules to word data but I am not able to do this. Would anyone have any suggestions on what I need to do to accomplish the conversion from X to WX and Y to WY.
Thanks,
Thanks,