Siemens PDM Force Closing

flyswatter

Member
F
Join Date
Apr 2012
Location
Wrexham
Posts
2
Have recently had to install PDM (V8.1 SP1, running with Step7 V5.5 SP3), to configure some Sitrans flow sensors.
Had no problems installing and transferring device definitions, but if I try to carry out any task in PDM (e.g. communication settings!), then I get an instant dialogue box of:
Siemens.Automation.Pdm.FrameApplication has stopped working.
Can't find any threads or searches, so I'm not holding out much hope that many people have had the same issue... But any ideas would be great!
 

Similar Topics

danw
Siemens PDM with Step 7 300 system
An ethanol plant was closed down, sold, is now running under new owner. It needs a couple replacement temperature transmitters. The plant is...
Replies
0
Views
2,562
danw
danw
J
Profibus Class 2 master - Siemens PDM
I have what appears to be a somewhat unusual configuration. I have a Compact Logix, with a ProSoft Profibus DPV1 master card, which is connected...
Replies
8
Views
6,403
Arowbotics
A
Fritz_frederix
PDM-software Siemens
Hi Folks, We are trying to install the Siemens PDM software v5.2 on a Dell laptop with an operatingsystem win 2000. The installing of the...
Replies
6
Views
4,284
Fritz_frederix
Fritz_frederix
W
Convert Codesys code to Siemens tia portal
Hi! What is the way to convert the code from the Codesys code to the Tia Portal? Regards, WK
Replies
4
Views
73
Wak
W
C
What is the Siemens name of their Servo Product Line and what Software is used ?
Good Afternoon , It has been decades since I have done anything with Siemens . What is the Siemens name of their Servo Product Line and what...
Replies
10
Views
208
bkottaras
B
Back
Top Bottom