Hey guys,
I am trying to 'seal' in a timer to execute some logic on a one-shot.
Below is a screenshot of what I have set up thus far...
What's nice is that it starts running on the one-shot, and continues to run until the timer expires. However, the -(S)- doesn't latch.
It seems like a race condition because the timer expires, turning on Q, and forcing the lower branch off. But I'd expect the timer to RLO true for at least one scan...
Am I way off base here?
This is an S7-1214 on FW2.0.2 (ick!), using TIA V11 SP2.
I am trying to 'seal' in a timer to execute some logic on a one-shot.
Below is a screenshot of what I have set up thus far...
What's nice is that it starts running on the one-shot, and continues to run until the timer expires. However, the -(S)- doesn't latch.
It seems like a race condition because the timer expires, turning on Q, and forcing the lower branch off. But I'd expect the timer to RLO true for at least one scan...
Am I way off base here?
This is an S7-1214 on FW2.0.2 (ick!), using TIA V11 SP2.