Siemens s7-200 motion control

suboliu

Member
S
Join Date
Oct 2010
Location
windsor
Posts
266
Hello all,
I need help, when I program s7-200, I use tool motion wizards to create AXISO_GOTO,see attach
its input has a speed and output has a C_Speed. but when I change input speed vaule, the step motor didn't change speed. and speed very slow. I monitor input speed vaule, it changed. but output C_speed didn't change very very low. why?
any suggestion will appreciate!

Untitled.png
 

Similar Topics

K
Siemens S7-1200 with Omron M1 - Modbus RTU
Hi all, Currently having trouble getting a speed reference to write over modbus to an Omron M1... I can successfully write a run command and...
Replies
6
Views
284
KalvMavin
K
H
comment communique siemens s7-1200 avec vfd delta
commentaire communiqué siemens s7-1200 avec vfd delta ? (cablage et sur tia portal )
Replies
0
Views
148
houssem02
H
M
Siemens S7 1200 CP2341 ethernet
Hi, I have a 1214 on ip 192.168.0.100. This is connected to other modules through a switch on same network. I need to connect this to a company...
Replies
1
Views
193
tarik1978
T
G
Siemens S7-1200 firmware upgrade
Hi Experts, I would like to make firmware upgrade from v3.0 to v4.5 (S7-1200 CPU 1215C). Can I do it from v3.0 to v4.5? Do I need to take some...
Replies
6
Views
322
goghie
G
R
Siemens S7-1200 profinet communication with codesys plc
Hi Guys, I am trying to establish communication over profinet between Siemens S7-1200 PLC as IO device and codesys plc as IO controller. But I am...
2 3
Replies
43
Views
2,963
raghu_k
R
Back
Top Bottom