Hello All,
I need to change the page on a Siemens OP270B Display from the PLC. I understand that within the “Area Pointers” section it’s possible to see the current page number but I cannot find where to send a page change request from the PLC. I’m assuming this can be done? Any ideas?
Thanks Qee
I need to change the page on a Siemens OP270B Display from the PLC. I understand that within the “Area Pointers” section it’s possible to see the current page number but I cannot find where to send a page change request from the PLC. I’m assuming this can be done? Any ideas?
Thanks Qee