Hairyvelcroman
Member
Hi
We have a SIWAREX 231 weighing card controlled via PLC (not stand alone)
We have used these for a while with no issues. We can auto and manual calibrate the cards using SIWATOOL.
We have an issue with a silo when it is at half capacity and emptying, the weights are accurate. But when we fill the silo and discharge, the weights are inaccurate. The option of only discharging whilst half full isn't an option.
We usually just use Calibration 0 and Calibration 1. To try and improve this, we wanted to use Calibration 2. However, we had the following faults:
5003 service mode cant be switched off calibration not completed
7007 Calibration weights/ Calibration digits not plausible
What does this mean? The manual doesn't really explain it, and I cant find anyone else experiencing this.
Calibration 0 and 1 and shown in bold, but Calibration 2 isn't.
Thanks
Nathan
We have a SIWAREX 231 weighing card controlled via PLC (not stand alone)
We have used these for a while with no issues. We can auto and manual calibrate the cards using SIWATOOL.
We have an issue with a silo when it is at half capacity and emptying, the weights are accurate. But when we fill the silo and discharge, the weights are inaccurate. The option of only discharging whilst half full isn't an option.
We usually just use Calibration 0 and Calibration 1. To try and improve this, we wanted to use Calibration 2. However, we had the following faults:
5003 service mode cant be switched off calibration not completed
7007 Calibration weights/ Calibration digits not plausible
What does this mean? The manual doesn't really explain it, and I cant find anyone else experiencing this.
Calibration 0 and 1 and shown in bold, but Calibration 2 isn't.
Thanks
Nathan