zygler Member Z Join Date Mar 2009 Location Bangkok Posts 2 Jul 14, 2010 #1 I use SLC500 5/05 in my process but I cannot apply the Processor run on 100Mbps. I config it to use auto-negotiate but the processor still run on 10Mbps half duplex. Anyones can recommend me how to? Thank
I use SLC500 5/05 in my process but I cannot apply the Processor run on 100Mbps. I config it to use auto-negotiate but the processor still run on 10Mbps half duplex. Anyones can recommend me how to? Thank
widelto Member Join Date Jul 2005 Location Barranquilla, Colombia Posts 3,392 Jul 14, 2010 #2 How about your switch, is this configured to 100 mbps ??
OkiePC Lifetime Supporting Member Join Date Mar 2005 Location ENE of Nowhere Oklahoma Posts 11,794 Jul 14, 2010 #3 Some of the older 5/05 cannot run above 10Mbps. Make sure your unit has a new enough ethernet daughterboard. Can you post the firmware revision on the 5/05 label? Compare that with what is shown in RSLogix 500.
Some of the older 5/05 cannot run above 10Mbps. Make sure your unit has a new enough ethernet daughterboard. Can you post the firmware revision on the 5/05 label? Compare that with what is shown in RSLogix 500.
zygler Member OP Z Join Date Mar 2009 Location Bangkok Posts 2 Jul 14, 2010 #4 Thank I wiil post the pic later.