desa
Member
Good afternoon. Below is the network diagram, according to which I wanted to configure supervisor on en2tr module. Stratix is in RSTP mode, due to which it blocks one of the Gi1/2 ports on one of the lines. The Gi1/2 has Multiport Automation Device roles. When I enable the first supervisor on the en2tr module, I can only see the backplane addresses that are installed in the same cabinet. I cannot see the backplanes that are installed in other locations. I communicate with them via fiber optic line. This is the question, why I can't see the backplanes of other cabinets with the supervisor, which are always connected in both PLC and RSLinx. Time synchronization is disabled temporarily (because there is no server). Speed is set to 100 everywhere.
What am I missing ?
Thanks for the answers.
What am I missing ?
Thanks for the answers.