Hello Experts,
I'm wondering if this has been done before if possible to create an Emulate file that have motion control axis? I tried to search and check for this type of configuration but i was not successful.
Since there are hardware involved where the motion axis is connected to certain drives. So before i start and deleting some of this hardware, i would like to know if there is a possibility of doing this?
I'm wondering if this has been done before if possible to create an Emulate file that have motion control axis? I tried to search and check for this type of configuration but i was not successful.
Since there are hardware involved where the motion axis is connected to certain drives. So before i start and deleting some of this hardware, i would like to know if there is a possibility of doing this?