what is your load resistance manual says min 4K. I know you said you tried it with no load btu am grasping at straws at this point.
Yes its 4k,
We have tried it with no load connections and get same result.
We have tried it with resistors across the terminals and get same result.
I have spent the morning on the phone with AD Tech Support and we upgraded the firmware, went through all the configurations, retried most everything I have been trying already and still get the same result.
Tech Support came up with the same conclusion I did...... "Something is not right".
They are handing it off to the factory and will get back to me when they hear something further.
We just left the dock and will be fishing within 12 hours so I have locked the motorized valves in the 20% position and pulled the fuses. We are going to to run the plant in a semi-automatic state so we can keep this monster moving toward the finish line.
I will say this for Automation Direct, their tech support is very good.
You call the number give your company name and 30 seconds later you are talking to a real person that knows whats going on....*For Free*.... Man if that ain't refreshing. They definitely get an A+ for customer service in my book.
I am sure I will warm up to their products and software also as I use them more and get a better feel for them.
Thanks for all the input guys, I really appreciate it.
BCS