Hello,
I have a service engineer on site, and he is struggling with a touch panel.
The touch pointer is way off where he is pressing the touch screen.
So much that he is not able to go into control panel and calibrate it.
Does anybody know any other method to fix this, if there is any dip switch setting or anything that resets the panel completely?
Or is it scrap?
Thanks for suggestions!
Andreas
I have a service engineer on site, and he is struggling with a touch panel.
The touch pointer is way off where he is pressing the touch screen.
So much that he is not able to go into control panel and calibrate it.
Does anybody know any other method to fix this, if there is any dip switch setting or anything that resets the panel completely?
Or is it scrap?
Thanks for suggestions!
Andreas