i need some one to help me out.
i,m trying to transfer my first program to a PLC
i,m trying to do this with GX-developper FX. i,m using a mitsibushi FX 2n PLC. when i try to this, i get the following error;
1 cable error(i dont think this is the problem, i am using new cables)
2 specify baud rate not supported( i don,t think this is the problem to, i have tried all possible baud rate)
3 the project PLC and the connected PLC are different(i know this is not the problem)
4 monitor set staus is read by Device(what does this means?)
what else could it be??>>
i,m trying to transfer my first program to a PLC
i,m trying to do this with GX-developper FX. i,m using a mitsibushi FX 2n PLC. when i try to this, i get the following error;
1 cable error(i dont think this is the problem, i am using new cables)
2 specify baud rate not supported( i don,t think this is the problem to, i have tried all possible baud rate)
3 the project PLC and the connected PLC are different(i know this is not the problem)
4 monitor set staus is read by Device(what does this means?)
what else could it be??>>
Last edited: