Can anyone help me getting this communications connection set up between KINCO GL100 and KINCO K508-40AR?
I am using Port 1(RS485) on the KINCO PLC, set in Mosbus Master with port settings
Baud Rate 9600
Stop Bits 1
Parity None
Data Bits 8
Address 1
In the KINCO HMI I am using Com0,RS485
Communication protocol Kinco PLC Series
Baud Rate 9600
Stop Bits 1
Parity None
Data Bits 8
Station 1
I have made a cable up to run from the HMI to PLC as follows
HMI 9 Pin D plug PLC 9 Pin D plug
1 RX- -------------------------------- 3B
6 RX+ -------------------------------- 2A
Using this configuration appear PLC no response on the HMI
Any help would be appreciated
I am using Port 1(RS485) on the KINCO PLC, set in Mosbus Master with port settings
Baud Rate 9600
Stop Bits 1
Parity None
Data Bits 8
Address 1
In the KINCO HMI I am using Com0,RS485
Communication protocol Kinco PLC Series
Baud Rate 9600
Stop Bits 1
Parity None
Data Bits 8
Station 1
I have made a cable up to run from the HMI to PLC as follows
HMI 9 Pin D plug PLC 9 Pin D plug
1 RX- -------------------------------- 3B
6 RX+ -------------------------------- 2A
Using this configuration appear PLC no response on the HMI
Any help would be appreciated