We had developed the screens in pcim version 7.5 with out any SEK, only on demo version as it is our regular practise in the same fashion we had done more than 200 i/o's so many times.
Then we installed the software version 7.7 in the pc and copied the project screens developed in version 7.5.
Next we installed SEK 100 I/O (Runtime) key in parallel port and started running pcim.
When ever screen goes in operator workstation we are finding the below error "Cannot open display "screen name" it is not supported by current Software enable key 100 I/O. Display was developed for 20 I/O SEK or lower".
where as it is running in demo version with out any SEK
This type of problem we are facing for the first time we didnt faced such type of problem.
rahman
Then we installed the software version 7.7 in the pc and copied the project screens developed in version 7.5.
Next we installed SEK 100 I/O (Runtime) key in parallel port and started running pcim.
When ever screen goes in operator workstation we are finding the below error "Cannot open display "screen name" it is not supported by current Software enable key 100 I/O. Display was developed for 20 I/O SEK or lower".
where as it is running in demo version with out any SEK
This type of problem we are facing for the first time we didnt faced such type of problem.
rahman