Hello
I have to replace a wago module and i would like to know if their is something software to configure on the remote hardware itself or if everything is on the plc program.
A red light is lit and i found the meaning of that light on the spec to be an hardware problem of the module itself.
I have seen profibus adress dipswitch and i expect it to be the only thing to figure out but i never worked with that and i haven't so much info on the system...
Should i be aware of more?
I have to replace a wago module and i would like to know if their is something software to configure on the remote hardware itself or if everything is on the plc program.
A red light is lit and i found the meaning of that light on the spec to be an hardware problem of the module itself.
I have seen profibus adress dipswitch and i expect it to be the only thing to figure out but i never worked with that and i haven't so much info on the system...
Should i be aware of more?