planetneutral
Member
How do you set up a message block for a REMOTE IO unit? (using ethernet IP)?
Wago remote io
- Thread starter planetneutral
- Start date
Is this related to your other post regarding MSG on the Logix platform?
I suppose you could do it that way, but better to configure your bus coupler as an I/O device. When I did this about a decade ago WAGO had a video and pretty good documentation. And I had decent hands-on help from the local technical sales rep.
I suppose you could do it that way, but better to configure your bus coupler as an I/O device. When I did this about a decade ago WAGO had a video and pretty good documentation. And I had decent hands-on help from the local technical sales rep.
Similar Topics
I have a project to setup base programs across multiple PLC platforms that can be used for Modbus communications to various sensors that have...
Hello all. I am doing my 1st project using an AB Compactlogix and Wago remote I/O across Ethernet I/P. It seems you can either "roll your own"...
Hi there,
I’m not sure how familiar most of you are with Wago remote I/O, but I hope you may have some solution for the following connection...
Hello
I have to replace a wago module and i would like to know if their is something software to configure on the remote hardware itself or if...
Hi,
Do any one have idea how to read the status of he WAGO I/O modules
installed remotely and coonect to 1756-ENBT thru Ethernet TCP/IP.
Wago...
