Question on Weintek,Weinview, HMI trouble shooting. I've noticed if I have a bad address on an object it will compile(successful) and download. HMI will
communicate wit PLC in a live test but will flash the "NO PLC Response" bar
most likely because it is looking for an address that doesn't exist or an object, button has been addressed wrong.
My question is there an easy way of finding the objects that are not communicating, I have been creating screens and importing them into a project one at a time to see where my errors are, this can be a pain as well since I have to remove references to screens no imported yet as I test one by one or I import in grouped and still go through each screen if an error shows up
"No PLC Response"
I am even unsure if that only shows up on a page that has an error and not on a good page.
Any one have any insight. Thanks
communicate wit PLC in a live test but will flash the "NO PLC Response" bar
most likely because it is looking for an address that doesn't exist or an object, button has been addressed wrong.
My question is there an easy way of finding the objects that are not communicating, I have been creating screens and importing them into a project one at a time to see where my errors are, this can be a pain as well since I have to remove references to screens no imported yet as I test one by one or I import in grouped and still go through each screen if an error shows up
"No PLC Response"
I am even unsure if that only shows up on a page that has an error and not on a good page.
Any one have any insight. Thanks