vlad.colesnic
Member
Hello everybody!
Did you ever notice that if you type wrong the password set in a WinCC flexible operator panel three times, the panel disables your account by giving you the message: you have insufficient authorisation? I only managed to "come back into authorisation" by downloading again the project into the panel. Do you know any other solutions? Or is it possible to disable this feature? I have a lot of undisciplined operators here. At least I could put the retry number up to 1000 but I cannot find a setting to allow me to do this.
Thanks in advance,
Vlad Colesnic
Did you ever notice that if you type wrong the password set in a WinCC flexible operator panel three times, the panel disables your account by giving you the message: you have insufficient authorisation? I only managed to "come back into authorisation" by downloading again the project into the panel. Do you know any other solutions? Or is it possible to disable this feature? I have a lot of undisciplined operators here. At least I could put the retry number up to 1000 but I cannot find a setting to allow me to do this.
Thanks in advance,
Vlad Colesnic