jairus
Member
Hello experts,
Can anyone help me in Wincc Flexible 2008 SP2 to transfer a program from my laptop to MP277 10" touch. via S7 PC adapter USB (6es7972-0cb20-0xa0).
In HMI i set:
-Channel 2
-profibus/mpi/s7 ethernet
-enable channel: mpi > properties> adress 3
In my laptop i set:
-setPG> pc adapter (auto)>adress 3
-during transfer:
wincc transfer>mode>mpi/dp.adress 3
and i set tranfers mode also in HMI.
after a few seconds it will display " COULD NOT ESTABLISH COMMUNICATION"
i hope you can help me here.
thank you in advance.
Can anyone help me in Wincc Flexible 2008 SP2 to transfer a program from my laptop to MP277 10" touch. via S7 PC adapter USB (6es7972-0cb20-0xa0).
In HMI i set:
-Channel 2
-profibus/mpi/s7 ethernet
-enable channel: mpi > properties> adress 3
In my laptop i set:
-setPG> pc adapter (auto)>adress 3
-during transfer:
wincc transfer>mode>mpi/dp.adress 3
and i set tranfers mode also in HMI.
after a few seconds it will display " COULD NOT ESTABLISH COMMUNICATION"
i hope you can help me here.
thank you in advance.