mace
Member
Is there any issue introducing wires from a different power supply to my enclosure?
Currently, I have an HMI that will be powered by one source and push buttons in the same enclosure that will be attached to another power supply. These push buttons are used to interact with a three wire motor starter circuit. Different contacts on the push buttons will go to different power supplies, but no single contact will go to both power supplies.
Does the fact that there will be wires from two different power sources in the same enclosure bring up any issues?
Thank you for any assistance!
Currently, I have an HMI that will be powered by one source and push buttons in the same enclosure that will be attached to another power supply. These push buttons are used to interact with a three wire motor starter circuit. Different contacts on the push buttons will go to different power supplies, but no single contact will go to both power supplies.
Does the fact that there will be wires from two different power sources in the same enclosure bring up any issues?
Thank you for any assistance!