So for the last couple of days I've been trying to get an Automation Direct Click PLC to connect to Wonderware Intouch Machine Edition to no avail. I'm a student of Tim Callinan, who pointed me to this forum. I am working with him on a mechatronics trainer for high schools and community colleges. Our next step is to get it running with an HMI or SCADA software.
The Click PLC uses the Modbus RTU protocol over Ethernet and will connect to the Click Programming Software, but for the life of me I can't get it to connect to Wonderware.
I've tried all of the MODBUS drivers they offer and when I go to connect and type in the target station host IP (the IP address of the CLICK PLC) is gives me the Error Code: 10061 (failure to connect). I've setup the MODBUS setting to the correct IP and port (502) and still nothing.
I've scoured the intouch knowledge base and still've got nothing
Any ideas of what I'm doing wrong or pointers in the right direction would be super helpful.
The Click PLC uses the Modbus RTU protocol over Ethernet and will connect to the Click Programming Software, but for the life of me I can't get it to connect to Wonderware.
I've tried all of the MODBUS drivers they offer and when I go to connect and type in the target station host IP (the IP address of the CLICK PLC) is gives me the Error Code: 10061 (failure to connect). I've setup the MODBUS setting to the correct IP and port (502) and still nothing.
I've scoured the intouch knowledge base and still've got nothing
Any ideas of what I'm doing wrong or pointers in the right direction would be super helpful.