stephendbarnes
Member
I know this is not strictly a PLC question but here goes.
I have a Yaskawa P1000 drive that is configured to be switched from local to remote via a terminal input(#5). The drive is configured as two wire with reverse operation disabled. While in remote, the drive is configured to accept reference and run from terminals. When in local via terminal 5 (Jumpered to terminal 4 configured for alternate reference) the configuration receives reference from the keypad and run from terminal input. BTW this drive's inputs have been set up as sinking. When switching to local, the drive does not start as desired even though all inputs are valid for it to do so. It does accept reference from the keypad, and can only be started by the keypad even though the configuration says different.
Any help would be appreciated as Yaskawa says this should work though it does not on several new units being configured in our shop.
I have a Yaskawa P1000 drive that is configured to be switched from local to remote via a terminal input(#5). The drive is configured as two wire with reverse operation disabled. While in remote, the drive is configured to accept reference and run from terminals. When in local via terminal 5 (Jumpered to terminal 4 configured for alternate reference) the configuration receives reference from the keypad and run from terminal input. BTW this drive's inputs have been set up as sinking. When switching to local, the drive does not start as desired even though all inputs are valid for it to do so. It does accept reference from the keypad, and can only be started by the keypad even though the configuration says different.
Any help would be appreciated as Yaskawa says this should work though it does not on several new units being configured in our shop.