I don't do it like this...
I'm not 100% but if you did this with a new out of the box unit, wouldn't you upload and write over your projects original drive profile, parameters and data links? Perhaps not, I simply don't use this method perhaps I'm wrong about that, it is what I would be worried about happening ever since I goofed a replacement and long story short, ended up using FRN 1.XYZ to get running again without doing a download...
My method. I take it out of the box, hard factory reset as a habit, assign IP via parameters set, set the the IP and subnet, power cycle, flash the firmware from Studio, download to drive. This is just what works for me.