mcginnis535
Member
Hello newbie to the plc board
I am trying to upload a program from a new to me machine
(hyd press special built). It's running a 501 with 1k mem
I am able to communicate with the processor (rslinkx works and
I can see the processor name) but a can't
look at or upload the ladder logic. when I try the upload
I get a compiler error and a file open / file corrupt /
or user does not have access error.
PLC is in the run mode and operation good/ok.
This 501 has no key switch on the processor
I have created a file with the same processor and name
but it still will not upload the ladder logic
Any help would be greatly appreciated
Thanks
McGinnis535
I am trying to upload a program from a new to me machine
(hyd press special built). It's running a 501 with 1k mem
I am able to communicate with the processor (rslinkx works and
I can see the processor name) but a can't
look at or upload the ladder logic. when I try the upload
I get a compiler error and a file open / file corrupt /
or user does not have access error.
PLC is in the run mode and operation good/ok.
This 501 has no key switch on the processor
I have created a file with the same processor and name
but it still will not upload the ladder logic
Any help would be greatly appreciated
Thanks
McGinnis535