Analog Inputs to ELC

btroxell

Member
B
Join Date
Jul 2008
Location
Kokomo, IN
Posts
2
I have two sensors that output from 0 to 5 VDC.
How do I process these input signals in an Eaton Logic Controller ELC-PV28. I need to take the voltage and multiply by 20. This number will then be used to determine if a coil turns on.
I am very new to PLCs so any help is greatly appreciated.
 

Similar Topics

dalporto
Rockwell IOFlex Analog Inputs status
Hi all. I have 1793-IE4 (4)analog inputs modules in a 1794-ADN IOFlex DeviceNet Rack. I cannot find if I can I have access to individual channel...
Replies
1
Views
75
dalporto
dalporto
J
Single End vs Differential Analog Inputs
I am converting a SLC 500 to a Compact Logix. I plan on using a Compact Logix 5380 with conversion Kit. The problem is that the analog input cards...
Replies
1
Views
161
OkiePC
OkiePC
S
Simulate/Force Analog Inputs with Emerson RX3i PACSystems?
Hi there, I'm doing some extensive testing and commissioning with a slew of new Emerson PACSystems RX3i PLCs. It would be convenient to...
Replies
5
Views
197
Steve Bailey
Steve Bailey
O
Message Read entire Analog Inputs from CompactLogic to another CompactLogic PLC
Hello I need to message read the entire 16 channel raw analog inputs from a 1769-L33ER Compact Logic controller to another 1769-L33ER Compact...
Replies
8
Views
272
Ones_Zeros
O
B
SLC500 5/05 Analog Inputs Bouncing
I have a SLC500 5/05 and we have an alarm setup to monitor the status of the Analog Inputs we have wired to a 1746-NI8. We are using 5 of the...
Replies
14
Views
2,863
OkiePC
OkiePC
Back
Top Bottom