Roy Matson
Member
I have been running RSLogix Ver 16 and RSView Studio ME ver 4.0 for quite a while.
Recently I purchased a support agreement so that I could upgrade RSLogix 5000 to Ver 18
I loaded the new versions of RSLogix 17,18 & 19 this software seemed to start and run OK but it completely screwed up my RSView Studio, it would no longer open.
I did not upgrade this package.
Talking to support they told me I must upgrade the HMI software, I installed ver 5 which came with the support contract.
Then when I tried to open I get the message
VStudio does not appear to be registered
Much talking back & forth with support, un-installing, installing Rockwell software all to no avail.
Anyone had a similar issue?
Roy
Recently I purchased a support agreement so that I could upgrade RSLogix 5000 to Ver 18
I loaded the new versions of RSLogix 17,18 & 19 this software seemed to start and run OK but it completely screwed up my RSView Studio, it would no longer open.
I did not upgrade this package.
Talking to support they told me I must upgrade the HMI software, I installed ver 5 which came with the support contract.
Then when I tried to open I get the message
VStudio does not appear to be registered
Much talking back & forth with support, un-installing, installing Rockwell software all to no avail.
Anyone had a similar issue?
Roy