allenreyes
Member
Hi!
I am having a hard time in acquiring the correct data from Carlo Gavazzi power meter model: WM14-96 with RS-485 connection. The modbus serial (RS-485) was converter to modbus ethernet using moxa gateway device, "model: MB3170".
Communication is already established using kepserver software (Modbus Ethernet as device driver is used).Modbus addresses based on WM14-96 manual mapped to kepserver are all good, but the data read is differ from the actual value displayed on WM14-96. See below example..
(ex.. VALUE DISPLAYED for Voltage_L1-L2 = 13.5 kV ;
VALUE READ from Modbus Address (40292) = 63222 (data format-WORD)
anyone can help ????
Thank you...
I am having a hard time in acquiring the correct data from Carlo Gavazzi power meter model: WM14-96 with RS-485 connection. The modbus serial (RS-485) was converter to modbus ethernet using moxa gateway device, "model: MB3170".
Communication is already established using kepserver software (Modbus Ethernet as device driver is used).Modbus addresses based on WM14-96 manual mapped to kepserver are all good, but the data read is differ from the actual value displayed on WM14-96. See below example..
(ex.. VALUE DISPLAYED for Voltage_L1-L2 = 13.5 kV ;
VALUE READ from Modbus Address (40292) = 63222 (data format-WORD)
anyone can help ????
Thank you...