psychosunshine
Member
I have a CompactLogix 5380 PLC.
When I try to change to Dual IP Mode I get the following error message.
EtherNet/IP Mode did not change. Please remove the SD card, if installed and set to load on power up.
I tried removing the SD Card. But, I am not familiar with the settings for power up.
What am I doing wrong?
When I try to change to Dual IP Mode I get the following error message.
EtherNet/IP Mode did not change. Please remove the SD card, if installed and set to load on power up.
I tried removing the SD Card. But, I am not familiar with the settings for power up.
What am I doing wrong?