Connect 2 controllers with EtherNet/IP through a router

You could also check into a NAT device like the A-B 1784-NATR. Use one -NATR per each "private-network" Compactlogix and network the public side of each -NATR to an IP address on the same network as your Omron PLC
 
You could also check into a NAT device like the A-B 1784-NATR. Use one -NATR per each "private-network" Compactlogix and network the public side of each -NATR to an IP address on the same network as your Omron PLC




^this.


When I mentioned Stratix earlier, I meant -NATR.
 

Similar Topics

Hi, We have been facing a issue with SCADAPack 474. Configuration is like below. RTU 474 + 6103 PS + 5606 IO Mix Module + 5414 DI Module Only...
Replies
0
Views
64
The past week we received a new piece of equipment from Germany which utilizes siemens controls. Typically in our company we use A.B. controls for...
Replies
12
Views
347
I'm using a SLC typed write from the ControlLogix5572 to the MicroLogix 1400, with path: 2, (MicroLogix IP). The ControlLogix equipment has a...
Replies
0
Views
122
Hello, As part of our project, we are using an M241 controller. This controller interfaces with an industrial computer and a router via a switch...
Replies
2
Views
153
Here's what happened, Operator turned on the disconnect for an auger while it was still running to cut power. Auger DID in fact turn off, but the...
Replies
8
Views
373
Back
Top Bottom