Hi everybody.
I have a question about interface between Rockwell PLC and Ovation DCS.
1st project, I see they can communicate via Prosoft module (modbus TCP/IP), and in Rslogic500 have some message to send signal to DCS.
2nd project, they communicate via Ethernet module. But I not see any logic to send signal to DCS. I just see some address like B3[0].0 is one of DI signal that DCS can read but how can send this Bit to DCS
Please tell me how can they do (some configuration is required)
Thanks
I have a question about interface between Rockwell PLC and Ovation DCS.
1st project, I see they can communicate via Prosoft module (modbus TCP/IP), and in Rslogic500 have some message to send signal to DCS.
2nd project, they communicate via Ethernet module. But I not see any logic to send signal to DCS. I just see some address like B3[0].0 is one of DI signal that DCS can read but how can send this Bit to DCS
Please tell me how can they do (some configuration is required)
Thanks