jdbrandt
Lifetime Supporting Member
{Old Indramat guy here} (*)
How do you 'jumper out', logically, a drive on a Kinetics 6000?
For example, I have a Power Module (Node 20) and three axis modules (Nodes 22, 24, 26), and want to isolate Node 26.
I move the last fiber connector, eliminating the last axis module, but completing the loop.
Logically, I should be (*) able to just disable/inhibit Node 26.
Nothing I tried worked.
What am I doing wrong?
How do you 'jumper out', logically, a drive on a Kinetics 6000?
For example, I have a Power Module (Node 20) and three axis modules (Nodes 22, 24, 26), and want to isolate Node 26.
I move the last fiber connector, eliminating the last axis module, but completing the loop.
Logically, I should be (*) able to just disable/inhibit Node 26.
Nothing I tried worked.
What am I doing wrong?