I was just asked to find a power supply that will limit its output to 24 VDC at 2 Amps without shutting down completely.
I am not sure that this is even possible but what they are looking for is:
PLC that runs at 2 Watts but can draw up to 15 Amps for 20 mS on power up. There is a slip ring between the PS and the PLC that is rated for 2 Amps at 24 VDC.
"As is" it does not work with a standard switching power supply.
Is there a solution other than the obvious, change the slip ring?
If so what would that be?
I am not sure that this is even possible but what they are looking for is:
PLC that runs at 2 Watts but can draw up to 15 Amps for 20 mS on power up. There is a slip ring between the PS and the PLC that is rated for 2 Amps at 24 VDC.
"As is" it does not work with a standard switching power supply.
Is there a solution other than the obvious, change the slip ring?
If so what would that be?