Hello
I'm having some problems setting up a MAVE block.
I have searched the forum but most of the threads have ended/died without a solid answer/solution.
The current setup is a 65000 Ltr tank, 4-20mA signal from a pressure transducer. I get a solid signal but the signal dithers around by about 500-800 Ltrs making the readout very hard for operators to read and make a recording for their paperwork.
I have attached a screen shot of my current program and how I have setup the block.
I have setup a Program Tag 'MAVE_DT1_LEVEL_SCALED' to store the values in but im not sure if I have done this correctly, it is setup as a REAL with a size of 100.
My input parameter is also a REAL so im not sure if this would also cause a problem? does it need to be a INT/DINT ?
I'm having some problems setting up a MAVE block.
I have searched the forum but most of the threads have ended/died without a solid answer/solution.
The current setup is a 65000 Ltr tank, 4-20mA signal from a pressure transducer. I get a solid signal but the signal dithers around by about 500-800 Ltrs making the readout very hard for operators to read and make a recording for their paperwork.
I have attached a screen shot of my current program and how I have setup the block.
I have setup a Program Tag 'MAVE_DT1_LEVEL_SCALED' to store the values in but im not sure if I have done this correctly, it is setup as a REAL with a size of 100.
My input parameter is also a REAL so im not sure if this would also cause a problem? does it need to be a INT/DINT ?