Hi everyone
I need help connecting a Micrologic 1400 PLC to Citect SCADA version 7.2. I am using the ABMLXEIP protocol to configure the IODevice in Citect. When I compile the Citect project and use Tag Debug to try and read a bit address on the Micrologix 1400 PLC I cant read anything. I dont know how to check if the PLC is communicating with Citect at all?
The Schneider Electric FAQ on ABMLXEIP (http://www.citect.schneider-electric.com/forum/showthread.php?t=8494) states that you need a 1761 NET-ENI Module for the protocol to work but I dont have one, instead I am using the RJ45 (COM Port 1) port configured as an Ethernet Channel on the Micrologix 1400. Is this the issue and if so, how do I communicate my Micrologix 1400 PLC with Citect without a 1761 NET-ENI Module?
Any help would be much appreciated thanks.
I need help connecting a Micrologic 1400 PLC to Citect SCADA version 7.2. I am using the ABMLXEIP protocol to configure the IODevice in Citect. When I compile the Citect project and use Tag Debug to try and read a bit address on the Micrologix 1400 PLC I cant read anything. I dont know how to check if the PLC is communicating with Citect at all?
The Schneider Electric FAQ on ABMLXEIP (http://www.citect.schneider-electric.com/forum/showthread.php?t=8494) states that you need a 1761 NET-ENI Module for the protocol to work but I dont have one, instead I am using the RJ45 (COM Port 1) port configured as an Ethernet Channel on the Micrologix 1400. Is this the issue and if so, how do I communicate my Micrologix 1400 PLC with Citect without a 1761 NET-ENI Module?
Any help would be much appreciated thanks.