Need help - motor control

Hey all,

I'm trying to do something very similar to CWLeong, only I'm using an USB Plug-And-Play device for a joystick (namely, a 3Dconnexion SpaceNavigator - http://www.3dconnexion.com/3dmouse/spacenavigator.php) which is connected to an Allen Bradley VersaView HMI. Any suggestions as to how I might be able to pull the axis coordinates of the joystick from Windows (running on the HMI) into the ControlLogix PLC I have interfaced to it (i.e., interfaced to the HMI)?

Thanks in advance for any suggestions :)!
 
Last edited:

Similar Topics

7
Need help understanding this old DC motor wiring diagram
https://imgur.com/a/kKPtzyP We are making improvements to these motor controls by replacing these old resistor banks and DC generator with DC...
Replies
3
Views
1,821
Vic
V
C
Need help with wiring a motor to clickPLC
I intend to use a clickPLC to turn a motor on and off for predetermined times. I am still very new to this and not sure exactly how I wire...
Replies
3
Views
1,547
jimtech67
jimtech67
K
I need help with simple stepper motor code.
Question 1: I am still new to this - I also might be asking for too much. - but i need help using Ladder Logic to run (rod style actuator motor)...
Replies
6
Views
1,722
khaledgenidy
K
G
Transducer ? Need analog signal for 250hp motor. Help
Hi I'm working on a project for a client who needs to automate the feed from a conveyor into a densifier powered by a 250hp 480v motor. I've...
Replies
14
Views
2,703
Mark Snodgrass
M
M
Need help with for/rev. motor control logic
Hello everybody Ok I can't get this . I want to know if I can use same input for either direction for./rev. And can...
3 4 5
Replies
63
Views
11,583
Lancie1
Lancie1
Back
Top Bottom