Omron CS1D (Long to Float)

whtrader

Member
W
Join Date
Aug 2006
Location
KL
Posts
37
Hi all,

I need help on converting a long to float. Also I find the below misleading. Is long and double the same? Pls advice. Thanks.



 
Double is 2 words - long is 4. DBL is 16 bit to 32 bit float, DBLL is 32 bit to 32 bit float. This applies to the CS1D-H.

Check the help in CX-Programmer - most of it is there.
 

Similar Topics

BobB
SMS messaging from an Omron CJ2M-CPU31
Has anyone done SMS messaging from an Omron CJ2J-CPU31 PLC? If so could you help please. Omron here in Oz have not had any experience doing this...
Replies
5
Views
174
BobB
BobB
I
omron cj2m with scada comunication
I have an old plc in the system I have, moxa nport was used to communicate with scada, I want to replace the plc with cj2m cpu33 and eliminate...
Replies
1
Views
64
IO_Rack
IO_Rack
J
Omron CJ2m cpu33 - reading codes
Hi all, i have 8 CJ2m plc units that show different numbers on the plc display and i am stuck on reading the info. my unit has an ip address of...
Replies
3
Views
108
chelton
C
K
Siemens S7-1200 with Omron M1 - Modbus RTU
Hi all, Currently having trouble getting a speed reference to write over modbus to an Omron M1... I can successfully write a run command and...
Replies
6
Views
258
KalvMavin
K
M
Struggling to get good connectivity with Omron PLC (CS) and KeserverEx
Hi There, I have couple of Omron PLCs connected on my kepserverex and my intouch reads data from kepserverex. I have been observing that roughly...
Replies
4
Views
144
Mihir_007
M
Back
Top Bottom