Omron CS1D (Long to Float)

whtrader

Member
W
Join Date
Aug 2006
Location
KL
Posts
37
Hi all,

I need help on converting a long to float. Also I find the below misleading. Is long and double the same? Pls advice. Thanks.



 
Double is 2 words - long is 4. DBL is 16 bit to 32 bit float, DBLL is 32 bit to 32 bit float. This applies to the CS1D-H.

Check the help in CX-Programmer - most of it is there.
 

Similar Topics

R
Omron device net fault
Good morning everyone I’m currently working on a omron device net and have a nord drive that fell off the network. I have limit knowledge in...
Replies
3
Views
139
Ricky Cuevas
R
M
Omron plc backwards compatibility
I've come across a system running omeron cx-programmer version 9.42. Am I going to need to find a legacy version of the software to edit and...
Replies
1
Views
86
IO_Rack
IO_Rack
BobB
SMS messaging from an Omron CJ2M-CPU31
Has anyone done SMS messaging from an Omron CJ2J-CPU31 PLC? If so could you help please. Omron here in Oz have not had any experience doing this...
Replies
5
Views
216
BobB
BobB
I
omron cj2m with scada comunication
I have an old plc in the system I have, moxa nport was used to communicate with scada, I want to replace the plc with cj2m cpu33 and eliminate...
Replies
1
Views
88
IO_Rack
IO_Rack
J
Omron CJ2m cpu33 - reading codes
Hi all, i have 8 CJ2m plc units that show different numbers on the plc display and i am stuck on reading the info. my unit has an ip address of...
Replies
3
Views
157
chelton
C
Back
Top Bottom