HI everybody, this is my first post on here,
I have 2 Omron NS8 TV00 V2 hmi's that i need to connect to a pair of mitsubishi plc's it is my first time trying to communicate between omron and mitsubishi and i am not too sure what exactly i need. first project is to connect to an FX3g-14M i have selected melsec f in the comms settings of CX designer but i dont know the comm speed data bits etc. also what cable / converters do i need.
the next one i'm really stumped on i want to connect to a Q00 cpu and the only info i could get so far is that there is no protocol to connect to system Q but it ''might'' work using a serial communications card on the rack.
Apologies if the answers to either of these questions are obvious but I am relatively new to this.
If anybody has done this before I would GREATLY appreciate some info.
thanks in advance....
I have 2 Omron NS8 TV00 V2 hmi's that i need to connect to a pair of mitsubishi plc's it is my first time trying to communicate between omron and mitsubishi and i am not too sure what exactly i need. first project is to connect to an FX3g-14M i have selected melsec f in the comms settings of CX designer but i dont know the comm speed data bits etc. also what cable / converters do i need.
the next one i'm really stumped on i want to connect to a Q00 cpu and the only info i could get so far is that there is no protocol to connect to system Q but it ''might'' work using a serial communications card on the rack.
Apologies if the answers to either of these questions are obvious but I am relatively new to this.
If anybody has done this before I would GREATLY appreciate some info.
thanks in advance....