Bagus
Member
Hi All, I just starting out CX-Programmer. I am currently using CPM1A.
At first day all is good and I can try different program using basic program such coils, contacts, Timer and Counter. But then in the second day my PLC dont give any output. I try to use simple program, like this :
----| |-----------O----
but the LED on the PLC's output display did not turn ON, and I look at the ladder diagram the contact and line turn green but the coil don't. I try to turn it off and on then transfer new program to PLC but it still the same
I'm still new with this and I can't find the solutions for this problem.
Hope you guys can help me with this problem. Thank you so much for your attention.
At first day all is good and I can try different program using basic program such coils, contacts, Timer and Counter. But then in the second day my PLC dont give any output. I try to use simple program, like this :
----| |-----------O----
but the LED on the PLC's output display did not turn ON, and I look at the ladder diagram the contact and line turn green but the coil don't. I try to turn it off and on then transfer new program to PLC but it still the same
I'm still new with this and I can't find the solutions for this problem.
Hope you guys can help me with this problem. Thank you so much for your attention.