JoeTech
Member
I have a new 10" PVP6 installed on our DH+ network (replaced legacy PV 1000). Since installing when I connect to the PLC with RSLinx (REV 3.60.00 CPR 9 SR 6) using RS500 (9.00.00 (CPR 9)) after a certain amount of time the spinning ladder in RS500 stops spinning and it does not update any information. I then have to go offline then back online and they update again for awhile until I have to repeat the process.
I am connecting via wireless through a 1756 ENBT/a to a 1756 DHRIO/b.
I have increased the update time on the Alarms (the only update time I could find) and this had no change. When I remove power from the PVP6 I have no problems with RS500 updating the data tables.
This only affects the PLC the PVP6 communicates with. There are 9 PLC's (all SLC 5/04), three PV550's and the one PVP6 on the DH network.
Any Ideas??
Forgot to add there is a computer using Ifix to get data from same PLC
I am connecting via wireless through a 1756 ENBT/a to a 1756 DHRIO/b.
I have increased the update time on the Alarms (the only update time I could find) and this had no change. When I remove power from the PVP6 I have no problems with RS500 updating the data tables.
This only affects the PLC the PVP6 communicates with. There are 9 PLC's (all SLC 5/04), three PV550's and the one PVP6 on the DH network.
Any Ideas??
Forgot to add there is a computer using Ifix to get data from same PLC
Last edited: