MATT116
Member
Studio 5000 Pro V24
Kinetix 350 drive
TLY motors
X axis 8" overall travel +4" and -4"
Y axis 8" overall travel +4" and -4"
I need to build a cam profile that then can be used by the MAPC instruction to "draw" an oval.
I know the finished required oval diameters.
The center of the oval will always be 0,0.
I guess where I'm stuck at is the equation required to take the know diameters and build the cam profile?
Kinetix 350 drive
TLY motors
X axis 8" overall travel +4" and -4"
Y axis 8" overall travel +4" and -4"
I need to build a cam profile that then can be used by the MAPC instruction to "draw" an oval.
I know the finished required oval diameters.
The center of the oval will always be 0,0.
I guess where I'm stuck at is the equation required to take the know diameters and build the cam profile?