I have a Cognex Insight 2000-130 camera that I'm trying to get talking to my PLC. Both are connected to the same router via Ethernet. Thus far I've followed the steps from Cognex's site (https://www.cognex.com/support/downloads/ns/1/11/91/Integration with RSLogix v1.pdf). My RSLogix is version 20.0.4 and I have downloaded AOP 1.28.
My problem is that once I configure my camera as a module under the Ethernet node, I get an error (code 16#0204 Connection request error: connection request timed out.) It's finnicky and seems to cut in and out though. Rarely it will run, at other times it will show error #0203 but it's most frequently in the timed out/IO Faulted state.
I have double checked the IP address of my camera, I can connect to it in Cognex's In-Sight Explorer. I've also configured the camera to have Ethernet/IP comms.
Any ideas? I've tried configuring as Generic Ethernet module, I've tried changing ports, DHCP is disabled, etc.
Insight Explorer diagnostic log:
192.168.2.251 is the IP address of the PLC's Ethernet card
My problem is that once I configure my camera as a module under the Ethernet node, I get an error (code 16#0204 Connection request error: connection request timed out.) It's finnicky and seems to cut in and out though. Rarely it will run, at other times it will show error #0203 but it's most frequently in the timed out/IO Faulted state.
I have double checked the IP address of my camera, I can connect to it in Cognex's In-Sight Explorer. I've also configured the camera to have Ethernet/IP comms.
Any ideas? I've tried configuring as Generic Ethernet module, I've tried changing ports, DHCP is disabled, etc.
Insight Explorer diagnostic log:
192.168.2.251 is the IP address of the PLC's Ethernet card