Steve Kemp
Member
- Join Date
- Nov 2003
- Posts
- 122
Hi all.
I'm testing a devicenet setup on the bench before installing it in a machine. It's a slc with 1747 scanner and some SMC pneumatics bits and pieces plus an AB 3000i servo. When I kill the line power to the servo, as would be the case in an E-stop situation, the scanner shows a status error as it has detected the power loss. That in itself is no big deal so long as it doesn't throw anything else off balance. Everything else seems OK (continuing to operate), but I wanted to make sure.... Any comments?
Thanks.
I'm testing a devicenet setup on the bench before installing it in a machine. It's a slc with 1747 scanner and some SMC pneumatics bits and pieces plus an AB 3000i servo. When I kill the line power to the servo, as would be the case in an E-stop situation, the scanner shows a status error as it has detected the power loss. That in itself is no big deal so long as it doesn't throw anything else off balance. Everything else seems OK (continuing to operate), but I wanted to make sure.... Any comments?
Thanks.