I'm trying to set the pass through up on a SLC 5/05 that is connected to a net work of SLC 5/03's via DH485 .Now I've got the Routing table set (I think) I've assigned IP address to the used node address in the routing table but still all I see is the 5/05 .The DH485 network is fine and I've even checked the cable from the 5/05 to the DH485 and I can see the network there.
Is it because I've got gaps in the routing table I.e node 13 is not used so I've left it in
Current mappings
0: Local 5/05
1: 0.0.0.0
2: 10.0.0.55
3: 10.0.0.56
ect
13: 0.0.0.0
ect
Is it because I've got gaps in the routing table I.e node 13 is not used so I've left it in
Current mappings
0: Local 5/05
1: 0.0.0.0
2: 10.0.0.55
3: 10.0.0.56
ect
13: 0.0.0.0
ect