Hi everyone
In the last month I have been called out to a factory to restart two different PLCs (TI525-1102) on two different machines.
Both refused to go into run mode when the power was cycled.
It was necessary to startup TISoft and manually set them to run.
Has anyone ever seen this behaviour and can you suggest a reason and/or remedy?
Regards
Glenn
In the last month I have been called out to a factory to restart two different PLCs (TI525-1102) on two different machines.
Both refused to go into run mode when the power was cycled.
It was necessary to startup TISoft and manually set them to run.
Has anyone ever seen this behaviour and can you suggest a reason and/or remedy?
Regards
Glenn