Hello,fellas!
I'm looking for alittle help on this project. I have a 60ft. 1"x1" steel rod moving towards a rotating shear to be cut into 9 inch pieces every 3/4 of a second, the rod is driven by a freq. Drive untill the shear takes the first bite after which the shear grabs and feeds itself. My problem is i can get the bar just past to the shear point and stop the drive as it waits for the shears to come around.the boss doesnt like the scrap waste and would like me to synchronize
the flywheel on the shear with the drive so they meet at the same time.would i be correct by just plugging in frequencies on the drive according to the degree of the revolution on the flywheel compared to the distance of travel needed? I could just say deal with it. Would appreciate any input,thanks.
I'm looking for alittle help on this project. I have a 60ft. 1"x1" steel rod moving towards a rotating shear to be cut into 9 inch pieces every 3/4 of a second, the rod is driven by a freq. Drive untill the shear takes the first bite after which the shear grabs and feeds itself. My problem is i can get the bar just past to the shear point and stop the drive as it waits for the shears to come around.the boss doesnt like the scrap waste and would like me to synchronize
the flywheel on the shear with the drive so they meet at the same time.would i be correct by just plugging in frequencies on the drive according to the degree of the revolution on the flywheel compared to the distance of travel needed? I could just say deal with it. Would appreciate any input,thanks.