trying to convert accusort 20 barcode to banner camera

best49erfan

Member
B
Join Date
Aug 2003
Location
Titusville FL
Posts
70
I have managed to make all the IO for the conversion to work. the problem is the rs232. the machine I am installing this on give me a EM50 module comm error. If i look at the camera data, the camera is sending 3 B1's to the camera but nothing out of the camera. the camera setup shows transmit header of <NAK><SO> and transmit Trailer of <CR>. it also shows receive header <STX> and receive trailer <CR><LF>. the issue I am having is I dont see how to enter all of this into the camera to get rid of the error and allow the machine to run. I have no access to program for the machine to change it.
 

Similar Topics

M
Trying to convert S5 program to S7
Hi everybody. I am trying to convert a program from S5 to S7 and having a few problems. I have managed to produce source code and open it within...
Replies
3
Views
5,249
sps-concept
S
A
Trying to get copy of Red Lion G315 HMI program but support upload was not ticked.
Hi All, As a precaution my company has been collecting copies all the HMI and PLC programs. I have recorded copies of most of our sites...
Replies
0
Views
91
Angus_Fergusson
A
J
Studio example, now trying in a Micro 820. There is no Control Data Type in CCW.
Replies
3
Views
180
JamesV
J
W
Trying to Load FactoryTalk View ME Program V_11 to Panel View with FactoryTalk View ME V_13
I can't seem to get the Panel View Plus 7 standard edition to downgrade to V_11, when I check the AB downloads and compatibility websites for this...
Replies
1
Views
150
plvlce
P
Mas01
S7 TIA Portal: Trying to use PLCSIM - Software Licence expiry?
Hi I used to be able to launch PLCsim without any problem. Now it tells me " STEP 7 Professional Licence is required to simulate this PLC"...
2
Replies
15
Views
617
Mas01
Mas01
Back
Top Bottom