VFD power calculation

Yes, there is another:
"Read accurate power value" - Correct the power to 1 decimal place.

The motor runs without load, and both these registers are zero.

I'll see if I can try to get a VFD under load to see what happens

/Tim
 

Similar Topics

T
Power Flex 525 did not run while the PLC command and VFD ready
I have an issue with Power Flex 525 during running processing, the VFD stopped suddenly while the PLC and VFD connection ok, VFD does not have any...
Replies
1
Views
138
jridge
J
L
Devicenet- power cycle on VFD kicks several nodes off network
We have a devicenet consisting of 15 PF755 drives in a centerline MCC, and on a separate trunk cable coming off the scanner, a single PF525 in a...
Replies
0
Views
352
lftmx3
L
G
VFD as DC power supply
I need small power supply that has very small ripple and 250VDC for my workshop. I came to idea to use DC bus from VFD that has 3x230VAC output as...
Replies
6
Views
2,104
goghie
G
J
Power Flex 755 VFD
A little background at my complex we run power flex 755 VFD's 480V most of them are 361 Amp. They are etherneted to a controller the VFD has a...
Replies
1
Views
5,471
Ken Roach
Ken Roach
T
power flex 700 vfd
I am using power flex 700 VFD. and motor is in open loop mode but continuesly break slip fault error show in drive display .
Replies
2
Views
1,357
Tushar More
T
Back
Top Bottom