timadsen01
Member
I apologize in advanced if this has been answered before but I was unable to find an answer searching the forum.
I have Wonder InTouch on a PC that is communicating via Ethernet over copper and radio. With our current radio configuration (which is planned to be upgraded in the future) the signal cuts in and out sometimes. Most of the time communication is re-established in InTouch with the Allen Bradley Micrologix PLCs but sometimes and individual PLC will not reconnect. With it in this state RSLinx will show the PLC connected and I can ping the IP address, I can even connect via RSLogix via another PC. It is not always the same PLC but it is always one that is on the radio backbone. Any ideas will be greatly appreciated.
I have Wonder InTouch on a PC that is communicating via Ethernet over copper and radio. With our current radio configuration (which is planned to be upgraded in the future) the signal cuts in and out sometimes. Most of the time communication is re-established in InTouch with the Allen Bradley Micrologix PLCs but sometimes and individual PLC will not reconnect. With it in this state RSLinx will show the PLC connected and I can ping the IP address, I can even connect via RSLogix via another PC. It is not always the same PLC but it is always one that is on the radio backbone. Any ideas will be greatly appreciated.