etomami
Member
I've got a Zelio SR3 relay and would like to connect the serial port to my PC (zelio soft) using an ethernet device server (Moxa N-port).
I've successfully used the Nport in the past to communicate with other serial devices, but I'm struggling with connecting to the zelio.
The n-port settings for baud rate, data bits, stop bits and flow control usually need to be manually configured to match the serial device and I suspect this is what's happening here. If I had known I was going to have this much fun with this I would have considered buying the USB cable and connecting directly with my laptop, but that wouldn't be near as much fun.
If you know what the serial comm's parameters are for the zelio, could you share them? It'll likely take me a year to figure them out by trial and error.
thanks in advance.
I've successfully used the Nport in the past to communicate with other serial devices, but I'm struggling with connecting to the zelio.
The n-port settings for baud rate, data bits, stop bits and flow control usually need to be manually configured to match the serial device and I suspect this is what's happening here. If I had known I was going to have this much fun with this I would have considered buying the USB cable and connecting directly with my laptop, but that wouldn't be near as much fun.
If you know what the serial comm's parameters are for the zelio, could you share them? It'll likely take me a year to figure them out by trial and error.
thanks in advance.